Woodburning Tool 2.0 or Dude, It Actually Works

It has been two weeks since my first post about learning to use my new woodburning tool. During those first few nights of learning, I didn’t think this follow-up post would be as positive as it is about to be. I didn’t think I would get the hang of it, I didn’t think it would be as fun as it is. I thought I would go running back to my trusty Gocco printer to finish my pieces for Artomatic. I was wrong and this is rad.

In the past few weeks, I have completed about 25 pieces, only ruining about 3! So far, I have only mastered transferring words, not images. Words are easier because you can concentrate on transferring each word, one letter at a time, making sure not to burn the paper into the wood. This is done by using the tool with one hand, while gently lifting the paper as you transfer. It is kind of how you check to see if a fake tattoo has transferred to your skin. Hard to explain. The instructions on the tool actually explained it, but until I messed it up a few times, it was hard to figure out. Transferring images has proven more difficult, so I am still working on that.

This piece is a combination of the star stamper that actually burns stars into the wood and the laser transfer (with multiple fonts):

Close up of the little stars:

Here is how it looks on the wall!

While this piece came out the best so far, the message is a little too cheerleader-y, so I held it back from the two shows I am making these for this month. (I wrote the text after having given birth to twins, so cut me some slack!)

You can see how the transfer really works well on the unpainted wood. I have found, though, that painted wood can be a little more difficult. A few tips so that you can learn from my mistakes.

1. Only let the pen/tool heat up for 5 minutes. Don’t turn it on, go off to watch Battlestar Galactica and come back an hour later. That thing will be too hot! It will then ruin the first half of whatever you are about to do. Along those same lines, don’t try to use a tool that hasn’t heated up.
2. If you plan to paint your pieces, do so the day before. Your paint needs to be completely dry before even trying this.
3. Don’t forget to reverse your images on a computer and then print them out. This can easily be done in Photoshop.
4. Read and follow all of the instructions on the package. I didn’t and this is what caused stress the first night.

Here are a few pieces that were painted before using the tool to transfer laser prints:

You might notice on these that the tool will sometimes transfer a faint clear bit when you run it over blank paper. I tried to minimize this by cutting my designs out very close to the ink. It isn’t a big thing, but might bother perfectionists. Transferring onto the painted pieces takes a bit more patience than the bare wood ones. Don’t be afraid to mess up and if you do, just paint over it and try again.

Of course, this tool can do like 20 other things. I urge people with drawing talent to try it out as a pen! I would love to see something other than deer heads and cowboys drawn on wood! I would really love to see what people with actual artistic ability can do with this tool. Don’t hesitate to comment on the blog if you do try it out. Along those lines, let us know about any kind of new craft you are trying to learn.

Tina Seamonster blogs her life and craft at http://www.ilikeseamonsters.com. Oh! You can see a whole wall of these finished pieces at Artomatic, 8th floor (SW, B7).

This entry was posted on Tuesday, May 13th, 2008 at 12:00 am and is filed under Tips & Hints, Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.